Description

SEAL-ONCE® Nano + Poly Premium Wood Sealer™ penetrates wood to create a long-lasting shield around the wood fibers, while forming a durable surface coating that protects against wear & tear, UV fading and water damage. Nano + Poly is safe for the environment as well. Seal-Once Nano + Poly Premium Wood Sealer combines proprietary silicate nanotechnology with the strength of polyurethane to provide 360 degrees of protection.

• Protects against Water, Mold, Decay and UV Fading
• Ultra Low VOC
• Non-Toxic
• No Odor
• A Penetrating Finish that Will Not Peel
• Water-Based Formula
• Safe and Easy Application and Maintenance
• Ideal for Exterior and Interior Application
• Soap and Water Cleanup

Seal-Once Nano + Poly Premium Wood Sealer Uses

• Log Homes
• Timber Frames
• Decks
• Railings
• Fences
• Shingles
• Shake Roofs
• Wood Siding
• Planters
• Outdoor Furniture
• Play Structures

Available Colors

Clear

Light Brown

Natural

Brown

Mahogany

Redwood

Bronze Cedar

Cedar

Black

Coastal Grey

Note: Tints are shown on Red Cedar. The clear finish (not Natural) will not have UV protection, but will have the same great waterproofing and warranty.

Coverage

Seal-Once Nano + Poly Requires Two Coats

• Actual coverage will vary due to porosity of the wood on which it is applied. In cases where Seal-Once Nano + Poly Premium Wood Sealer is applied to very dry, weathered or media blasted wood. 3 coats may be necessary.
• Seal-Once Nano + Poly Premium Wood Sealer is a two coat product. Applying less than two coats will greatly affect the durability of the product.

Product Facts for Seal-Once Nano + Poly Premium Wood Sealer

Application Temperature	50°F – 95°F
Application Methods	Brush Pump up Sprayer (Must Back Brush) Air Assisted Sprayer (Must Back Brush) Airless Sprayer (Must Back Brush) Do Not Use a Roller
	All Wood Cleaner is recommended to deep clean and prepare bare wood surfaces prior to applying Seal-Once Nano + Poly.
Surface Preparation	Clean, Dry, Bare Wood Surface Free of Dust, Mold and Mildew Moisture Content 22% and Below
Durability	Will prevent water from soaking into wood surface for up to 10 years on vertical surfaces and up to 6 years on horizontal surfaces.
Maintenance	Re-apply as needed
Special Instructions	Minimum 2 Coats Required Use 3 Coats on Very Dry or Weathered Wood Stir Thoroughly and Periodically Tint comes premixed for 1 Gallon buckets Tint is Added and Mixed in on Site for 5 Gallon buckets
Dry Time	Do not allow the first coat to dry before applying a second coat. The second coat should be applied while the first coat is still damp, but has penetrated into the wood. Apply the second coat within one hour of the first, following the same instructions. For best results, apply Seal-Once Nano + Poly Premium Wood Sealer in the shade and out of direct sun. Allow approximately 3-4 hours depending on temperature and humidity before subjecting the surface to light foot traffic. Allow 24-48 hours for the product to fully cure.